joe@cpr.com Posted July 18, 2017 Share Posted July 18, 2017 Bosko brought us his Z from vegas awhile back to do some bolt on's to it. Well he quickly grew tired of that and contacted us again to push it a little more. So this round we did the following to his car. LME Ported LT4 heads CPR spec cam 32% lobe CPR low side fuel system CPR heat exchanger His car is an A8 and has our 2.3 upper and a IW lower pulley, longtubes, CAI on it. He made in 112 degree air w/ absolutely zero meth 700/710! best part his high side pressure stayed a rock solid 2900 PSI. We do this the right way and the trick is making sure that HPFP is setup correctly and she will support a lot. He ran a previous best in Vegas at ls fest in 6000 DA 10.2 @ 136.x so this should help knock him over the edge even in junk air. The dyno graph shows his power when he was bolt ons w/ race gas vs now. https://www.youtube.com/watch?v=uwkZqnxT4lo Quote Link to comment Share on other sites More sharing options...
Recommended Posts